AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Span table lvl beam2/7/2024 ![]() Small Cabin Forum / Cabin Construction / Understanding LVL span charts for a ridge board Forums - Register/Sign Up - Reply - Search - Statistics. Getting ready to start designing our tongue and groove milled log cabin and i'm trying to figure out what i'm going to do for a ridge board to make the span. LVL seems to be a common solution, however, i'm struggling to understand their span charts. ![]() The cabin will be 30' long with 4.5" wide logs, so 29' 3" inside to inside. The local Menards uses Global LVL and their span chart is found here. Since this will be a ridge BOARD vs BEAM, do i just get a 30' that's tall enough for the 2x8" rafter cut end face to full rest on the side of the ridge board? For northern Wisconsin, the live load requirement is 40 psf, but for a 10/12 pitch it goes down to 30. Wood Products Engineered Lumber Microllam® LVL Microllam® LVL Beams Microllam® LVL beams work well in applications all over the house. If it's a ridge BOARD, it's not supporting any load, the rafter logs do that. if that's the case, a regular board would do, and it does not have to be continuous. The classic ridge BOARD joint is a scarf joint. But there is no real need to get so fancy for a rafter ridge board.Ī ridge board is a non-structural member that serves as a prop for opposing rafters to rest against and connect to. It is also used to keep the rafters spaced properly. Classic ridge BOARDS were one inch thick boards. The IRC still permits the use of a 1x board as the ridge board. Sizes and Weights of I Beams for Floors of Offices, Hote and Apartment - Houses Total load, 120 pounds per square foot Distance between centers. It is important to have a board deep enough to fully support the angled cut end of the rafters. Keeping the spacing from one rafter pair to the next is also very important. You can use lengths of whatever width board or 2x is handy and butt splice the ends. To calculate the size of the LVL beam simply divide the span in inches by 20 which gives the depth of the beam and the width of the LVL beam 1/3 or 1/4 of its depth. Use scraps of sheathing or subfloor to nail a scab on each side of the joint.
0 Comments
Read More
Leave a Reply. |